11-12-2012, 11:58 PM
#1
CF Member
Member Since: Nov 2001
Location: Glasgow Kentucky
Ky-parting out 1993 corvette - 37k miles
THE PARTS LISTED BELOW ARE ALL I HAVE LEFT
All of the following items were from a 1993 Corvette Coupe 37,944 Original Miles.
VIN #1G1YY23PXP5102752
All of the electronics have been tested and work as they should, including the radio, power antenna, A/C & Heater controls, seats, etc.
Body Parts:
Front Inner Fenders (Mounts to rocker panels) $60 each
Rear Fender Liners $50 each
Rocker Panels $65 each Plus Shipping
Gas Cap Access Door $50
Outside MIrrors $75 each
Electrical Parts:
90-93 DIC Panel $75
Manual Heat/ A/C Control Panel $50
Engine & Related Parts:
Engine Harness $300
Cruise Control Servo 90-96 $60
Interior Parts:
Several small trim pieces
Rear Cargo Shade $60
Lower RH Dash Panel $40
Lower LH Dash panel w/Carpet-Black $50
Door Panel LH $100 Plus Shipping
Dash Panel Bezel $50
Inner Dash Assembly $100
Upper Dash Assembly $200 (No Cracks!)
Glovebox Door $40
Seatbelt Set $
Steering/Suspension Parts:
Steering Column $250
Rack & Pinion
Miscellaneous Parts:
Windshield Washer Reservoir 84-96 $50
Suspension Parts:
Rack & Pinion 88-96 $100
I’m trying to update this list AND add pictures and pricing as I find other parts.
All prices include shipping within the continental United States by Fed Ex Ground unless stated. PayPal is accepted but cash in hand is always preferred! I am located in Glasgow, Kentucky, hallfway between Lousiville and Nashville off of I-65. All parts are sold as is.
Last edited by Cowansauto; 01-12-2013 at 01:51 PM .
11-13-2012, 09:26 AM
#2
CF Senior Member
Cruise-In III Veteran
Cruise-In IV Veteran
St. Jude Donor '12
Member Since: Mar 2001
Location: Life is just one big track event. Everything before and after is prep and warm-up and cool-down laps GA
What transmission is in it and what are you going to do with it??
11-13-2012, 09:48 AM
#3
CF Senior Member
Member Since: Apr 2011
Location: Exeter California
Front Side Marker Lights
Hi! are the front markers lights ant good? Price shipped to 93221. Thanks John
11-13-2012, 10:15 AM
#5
Tech Contributor
Member Since: Aug 2006
Location: Glendale Arizona.. Resident Gold Cylon
How much for the passenger door panel. What condition is it in? Any broken ribs etc?
__________________
GOLDCYLON - 91 ZR-1 #2014
380 P&P&PCed,Ported Heads,Jeal Long tubes,/Corsas/FIKSE FM-5s /LED TLs, HID Projectors, F/R Baer Eradaspeed Rotors with CE/GS RED/BL calipers,CNCed Coolant Pipes,TPI Cvr,Filter cover,Stainless Bolts, DRM/DOM PROM STG V /ZFDOC mod build #102,DRLs,BMAD with stainless Debris Screen,Coplan Air Blaster, Pioneer AVIC Nav system,Brey-Krause HB,Sub Bar,DRM Coilovers,APSIS Carbon Fiber interior
11-13-2012, 01:10 PM
#6
Auctioneer Administrator
Organizer St. Jude Fundraiser
Tampa Regional Coordinator
CI 4-5-6-7-8 Veteran
Member Since: Dec 1999
Location: Bad decisions make for great stories.
11-13-2012, 10:15 PM
#7
CF Member
Member Since: Nov 2001
Location: Glasgow Kentucky
Quote:
Originally Posted by
jaa1992
What transmission is in it and what are you going to do with it??
It along with the engine and transmission are not for sale. I still have the harness though.
Quote:
Originally Posted by
Bornwild
Hi! are the front markers lights ant good? Price shipped to 93221. Thanks John
No they were shattered!
Quote:
Originally Posted by
Ramjet
How much for the master brake cylinder?
I want....
$85 shipped
Quote:
Originally Posted by
Goldcylon
How much for the passenger door panel. What condition is it in? Any broken ribs etc?
I'd split the pair if I must for $175 each.
Its in great shape.
The vertical ribs are nice and crack free.
Last edited by Cowansauto; 11-14-2012 at 02:25 PM .
11-14-2012, 08:11 AM
#8
Tech Contributor
Member Since: Aug 2006
Location: Glendale Arizona.. Resident Gold Cylon
Quote:
Originally Posted by
Cowansauto
It along with the engine and transmission are not for sale. I still have the harness though.
No they were shattered!
$85 shipped
I'd split the pair if I must for $175 each.
Its in great shape.
I'll inspect it VERY close when I get off work and edit this post with condition and info to keep the thread as clean as possible.
OK LMK usually the upper ribs are stress cracked. I already have one of those which is why I am asking. Thanks GC
11-14-2012, 02:26 PM
#9
CF Member
Member Since: Nov 2001
Location: Glasgow Kentucky
Quote:
Originally Posted by
Goldcylon
OK LMK usually the upper ribs are stress cracked. I already have one of those which is why I am asking. Thanks GC
Good news, they're nice and crack free!
TTT
11-14-2012, 02:37 PM
#10
Tech Contributor
Member Since: Aug 2006
Location: Glendale Arizona.. Resident Gold Cylon
Quote:
Originally Posted by
Cowansauto
Good news, they're nice and crack free!
TTT
Driverside same condition? I MAY go for the pair.
__________________
GOLDCYLON - 91 ZR-1 #2014
380 P&P&PCed,Ported Heads,Jeal Long tubes,/Corsas/FIKSE FM-5s /LED TLs, HID Projectors, F/R Baer Eradaspeed Rotors with CE/GS RED/BL calipers,CNCed Coolant Pipes,TPI Cvr,Filter cover,Stainless Bolts, DRM/DOM PROM STG V /ZFDOC mod build #102,DRLs,BMAD with stainless Debris Screen,Coplan Air Blaster, Pioneer AVIC Nav system,Brey-Krause HB,Sub Bar,DRM Coilovers,APSIS Carbon Fiber interior
11-14-2012, 07:06 PM
#11
CF Member
Member Since: Nov 2001
Location: Glasgow Kentucky
Quote:
Originally Posted by
Goldcylon
Driverside same condition? I MAY go for the pair.
The driver's side has a crack in the little tab that goes across the opening where the switch panel snaps in. I would repair it with hi-strength two part epoxy and it would be fine.
Aaron.
Last edited by Cowansauto; 11-14-2012 at 07:09 PM .
11-14-2012, 11:29 PM
#12
Tech Contributor
Member Since: Aug 2006
Location: Glendale Arizona.. Resident Gold Cylon
I'll stick with the passenger side only. How do we settle up? Paypal?
__________________
GOLDCYLON - 91 ZR-1 #2014
380 P&P&PCed,Ported Heads,Jeal Long tubes,/Corsas/FIKSE FM-5s /LED TLs, HID Projectors, F/R Baer Eradaspeed Rotors with CE/GS RED/BL calipers,CNCed Coolant Pipes,TPI Cvr,Filter cover,Stainless Bolts, DRM/DOM PROM STG V /ZFDOC mod build #102,DRLs,BMAD with stainless Debris Screen,Coplan Air Blaster, Pioneer AVIC Nav system,Brey-Krause HB,Sub Bar,DRM Coilovers,APSIS Carbon Fiber interior
11-14-2012, 11:34 PM
#13
CF Senior Member
Member Since: Sep 2012
Location: Murphy NC
I know the engine and trans are not for sale, but if it is a 6spd, would you aell the pedal pads?
11-15-2012, 01:09 AM
#14
CF Member
Member Since: Nov 2001
Location: Glasgow Kentucky
Quote:
Originally Posted by
Goldcylon
I'll stick with the passenger side only. How do we settle up? Paypal?
My PayPal account is aaron.cowan @t hotmail dot c0m
Quote:
Originally Posted by
NuckinFutz93
I know the engine and trans are not for sale, but if it is a 6spd, would you aell the pedal pads?
It was an AT car.
11-15-2012, 07:56 AM
#15
Tech Contributor
Member Since: Aug 2006
Location: Glendale Arizona.. Resident Gold Cylon
Quote:
Originally Posted by
Cowansauto
My PayPal account is aaron.cowan @t hotmail dot c0m
It was an AT car.
Paypal sent
__________________
GOLDCYLON - 91 ZR-1 #2014
380 P&P&PCed,Ported Heads,Jeal Long tubes,/Corsas/FIKSE FM-5s /LED TLs, HID Projectors, F/R Baer Eradaspeed Rotors with CE/GS RED/BL calipers,CNCed Coolant Pipes,TPI Cvr,Filter cover,Stainless Bolts, DRM/DOM PROM STG V /ZFDOC mod build #102,DRLs,BMAD with stainless Debris Screen,Coplan Air Blaster, Pioneer AVIC Nav system,Brey-Krause HB,Sub Bar,DRM Coilovers,APSIS Carbon Fiber interior
11-15-2012, 09:34 AM
#16
CF Senior Member
Member Since: Feb 2012
Location: Brandon MS
How much for the driver side front gill panel shipped to 39047?
11-15-2012, 10:41 AM
#17
CF Senior Member
Member Since: Oct 2005
Location: Marlow OK
Aaron,
I need driver side power door lock switch and pass side power window switch. Thanks.
11-15-2012, 05:40 PM
#18
CF Senior Member
Member Since: Sep 2012
Location: Johnstown Penna
I'm not sure what to call the part, the latch that holds the roof when it is off in the back of the car where the hatchback closes.... Have one of those for a great price?
11-15-2012, 08:35 PM
#19
Junior Member
Member Since: Oct 2010
Location: Nashville IL.
93 Vette parts
What shape is the 3rd brake light and reverse lights in ? Do you know if they will fit a 1994 ?
11-16-2012, 05:27 PM
Thread Tools
Search this Thread
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off