Parting Out 85
#82
Safety Car
I need the RH/Passenger fresh air intake screen located on the firewall under the wiper blade if it is still intact. I would consider one that the screen is damaged but the plastic piece is still in good shape. Gotta be cheap as well.
Thanks!
Thanks!
#83
Heel & Toe
Member Since: May 2005
Location: Vineland New Jersey
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
I'm looking for the passenger side hood spring and latch pin assembly with mounting hardware. It is the part that is missing from this photo: Let me know a price with shipping to 08360. Thanks.
#84
I need the air diffuser from the bread box on the passenger side of the car. I have an 86 coupe and assume that your 85 would be the same. Let me know if you want to sell it, how much, and ship it to 55328 in Minnesota
#86
hi my wish list
\seat belts if black
the door bezel defrosters sits on top of the door panel bout 1 inch by 3 inches black screws into top of panel with two screws.
also passenger side peice thats carpeted just below the dash with the foam in back and four studs on it also for mounting.
im in nova scocia canada too
\seat belts if black
the door bezel defrosters sits on top of the door panel bout 1 inch by 3 inches black screws into top of panel with two screws.
also passenger side peice thats carpeted just below the dash with the foam in back and four studs on it also for mounting.
im in nova scocia canada too
#90
Melting Slicks
Is the interior stripped out? The reason for my inquiry is that I have an 87. I am installing a T-56 in place of the 4+3, to do this I will have to cut the trans tunnel to remove the portion that the 4+3 shifter used. Then I will need to patch the tunnel. I would like to buy the section of the trans tunnel that has the shifter opening plus enough fore and aft to graft it in. I could just use mate and resin and build my own, but if I can get the tunnel out of a later car I think I can make it look a lot cleaner plus I can use a factory boot to seal it up. Would you be interested in cutting that portion out and selling it?
#91
dont need the metal cover just the iunderside i had the car paintedand can not get the damn springs right to save my life the lid just wont stay closed so i only need the underside to novas sciotia canada b2n2b4
#92
#97
do you still have the parts if so need the part that is behind the bread box in a lil metal alluminum container it should be bolted by three screws to the plastic cage about 5 inches by three by one inch
and if so shipped to ns canada b2n2b4
and if so shipped to ns canada b2n2b4
#99
part
Do you have the brake pressure warning switch connector. Part # 12117268 connects to the white piece on the side of your master cylinder. b lack with rubber inside of it 2 prongs on it.