Access to Vortech S-trim belt tensioner
10-05-2013, 05:23 PM
#1
Team Owner
Thread Starter
Member Since: Mar 2001
Location: Boston, Dallas, Detroit, SoCal, back to Boston MA
Posts: 30,607
Received 239 Likes
on
167 Posts
Access to Vortech S-trim belt tensioner
Tried changing the belt today
I could only see it from below
and that's after removing the blower to throttle body elbow
any hits?
what else needs to come of
thanks in advance
I could only see it from below
and that's after removing the blower to throttle body elbow
any hits?
what else needs to come of
thanks in advance
10-05-2013, 07:16 PM
#2
Melting Slicks
I have the V2 t trim, As I remember all that had to be removed was the intake curved piece. I used a deep socket cut down a bit and a ratchet and an extension handle and get it from the top. Its a Pain.
10-08-2013, 06:03 AM
#3
Team Owner
Thread Starter
Member Since: Mar 2001
Location: Boston, Dallas, Detroit, SoCal, back to Boston MA
Posts: 30,607
Received 239 Likes
on
167 Posts
I'm going to take it back to the shop
not just for that
I'm looking to soften the "hit" when the blower kicks in. and make it better for autocrossing.
not just for that
I'm looking to soften the "hit" when the blower kicks in. and make it better for autocrossing.
10-08-2013, 04:32 PM
#4
Melting Slicks
Doing an install on the 74 with a blowershop 250, they have to machine me a lower pulley, joy joy
Last edited by illenema; 10-11-2013 at 01:29 AM.