FS: Headers and custom sidepipes
#1
Burning Brakes
Thread Starter
Headers and custom sidepipes
I have a set of Dougs 1-7/8" small block sidepipe headers, and custom modied 4in sidepipes. Set is cermanic coated and comes with clamps and mounting hardware. Also I have good set of header bolts that come with them
Pipes have tapered cones inside that cut it from 4in down to 3in, and there are dynomax race bullet mufflers welding in line. This setup is extremely good flowing and has deep rumble at idle. Its fairly loud at WOT. But alot more tame them open pipes.
I'm asking $1,000 for set. I'm in CT was hoping for locate pickup
Set is used but was only on car for short time.
Pipes have tapered cones inside that cut it from 4in down to 3in, and there are dynomax race bullet mufflers welding in line. This setup is extremely good flowing and has deep rumble at idle. Its fairly loud at WOT. But alot more tame them open pipes.
I'm asking $1,000 for set. I'm in CT was hoping for locate pickup
Set is used but was only on car for short time.
#2
Instructor
Very nice car ! Wish I could swing the headers and side pipes, What is your rear wheel size and back spacing ? I have the same rear BFG DR tires I'm going to use on my 70 LT-1 with a 406ci.
Last edited by zebebad; 10-24-2020 at 09:07 PM.
#3
Burning Brakes
Thread Starter
The rear wheels are 15x10s 4.5in BS with a 28x10.5x15 stiff walled slick. I also have another set of same wheels with 275/60/15 MT drag radials.. i run toms offset trailing arms and a narrowed leaf spring. No fitment issues
The following users liked this post:
zebebad (10-27-2020)
#7
#8
Burning Brakes
Thread Starter
Sorry for late response
I still have them. located in wallingford Ct 06492
No fitment issues.. coating on sidepipes themselves was redone recently because i modified them with mufflers. The header coating is still pretty good, dulled out a little from heat up top and had a few minor scratches from install and removal. But no dents or fitment problems. And the parts of headers you see for outside and engine bay look good. These were installed for 1 season but car isn't driven much.
#9
Burning Brakes
Thread Starter