DIY Jeep Steering Conversion Parts FS
#1
Safety Car
Thread Starter
Member Since: Aug 2001
Location: North Easton Mass
Posts: 4,883
Likes: 0
Received 8 Likes
on
8 Posts
DIY Jeep Steering Conversion Parts FS
I started putting together a Jeep steering conversion but I eventually bought a Borgeson setup. This is most of the parts needed for a DIY conversion. You will still need hose, a U-joint or rag joint and a pittman arm.
The brackets were made from drawings posted on the forum and are 2 pieces of 1/4" thick aluminum screwed together. Tig-welding them would be even better. I have grade 5 bolts holding them on to the box but they should be replaced with the metric equivalent of grade 8.
I got the steering box at the local self-serve junkyard. This one looked like a recent replacement and wasn't rusted like the others.
I'm asking $150 + shipping for everything. Basically just trying to get back the $ invested in the parts (those fittings are expensive). Send me an email if interested. blair.richard@comcast.net
Rick B.
The brackets were made from drawings posted on the forum and are 2 pieces of 1/4" thick aluminum screwed together. Tig-welding them would be even better. I have grade 5 bolts holding them on to the box but they should be replaced with the metric equivalent of grade 8.
I got the steering box at the local self-serve junkyard. This one looked like a recent replacement and wasn't rusted like the others.
I'm asking $150 + shipping for everything. Basically just trying to get back the $ invested in the parts (those fittings are expensive). Send me an email if interested. blair.richard@comcast.net
Rick B.
#2
Racer
Rick, would you happen to have any install instructions or be able to direct me to some details on the install. hose connections, etc.
Also, could you check on shipping to 34471?
Thanks
Barry
Also, could you check on shipping to 34471?
Thanks
Barry
#3
Safety Car
Thread Starter
Member Since: Aug 2001
Location: North Easton Mass
Posts: 4,883
Likes: 0
Received 8 Likes
on
8 Posts
Rick B.