You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join Corvetteforum.com today!
Looks like they worked pretty well. The intakes look a little sunk though. Are you running 2.19 intake valves? Are you running these on a 454? You are going to lose a lot of compression, are you changing the pistons too? Also what size/offset rear wheel and tire are you running? Looks like N50 15s?
Tom, I believe these heads have the original valves and seats although I didn't check yet. I think they are sunk in because they were not set up for unleaded gas??? As stated in the original post...they need to be gone through/rebuilt.
The motor is a 396 .060 over with 12 1/2:1 slugs which I didn't find out until I took it apart. I'm still undecided on what motor I am going to use. This one needs to be bored to .070 so I am contemplating putting a 427 for it since the cost is about the same.
The wheels are original Ansen Torque Thrusts. 14X6 front and 14X7 rear. F70-14 and L60-14 respectfully.