Rookie's first attempt at a restoration...
#2822
Team Owner
#2824
Safety Car
Thread Starter
#2831
Safety Car
Thread Starter
All I did was putt around the street. There is too much debris on the road to be putting any power down, without causing damage to the wheel well finish. I simply did this because I felt I deserved to see it run at least once before I started prepping it for paint. It will not be getting driven again, other than moving it around the shop, until we finish showing it. We still need to cut the front springs.
Let me know if you have any problems with the video.
Let me know if you have any problems with the video.
Last edited by stinger12; 04-05-2014 at 02:07 PM.
#2834
Nam Labrat
Member Since: Sep 2013
Location: New Orleans Loo-z-anna
Posts: 33,899
Received 4,179 Likes
on
2,739 Posts
I spent hours reading your thread...I know after all your work, you had a blast just going down the street!
It gives me hope on my Bubbarized '68!
#2836
Drifting
That has got to put a smile on your face. The car looks and sounds fantastic, and its not even finished yet. You have to be very proud of your accomplishments. Congrats.
Terry
Terry
#2837
All I did was putt around the street. There is too much debris on the road to be putting any power down, without causing damage to the wheel well finish. I simply did this because I felt I deserved to see it run at least once before I started prepping it for paint. It will not be getting driven again, other than moving it around the shop, until we finish showing it. We still need to cut the front springs.
Let me know if you have any problems with the video.
Let me know if you have any problems with the video.
#2838
Safety Car
All I did was putt around the street. There is too much debris on the road to be putting any power down, without causing damage to the wheel well finish. I simply did this because I felt I deserved to see it run at least once before I started prepping it for paint. It will not be getting driven again, other than moving it around the shop, until we finish showing it. We still need to cut the front springs.
Let me know if you have any problems with the video.
Let me know if you have any problems with the video.
Wow, Jeremy. I am liking it. Congrats..... BK3