62fuelie

Selling my 67 coupe. Has matching nos 327/350, 4 speed. Factory air, power steering and brakes. Very likely this car was an original big block car, but no tank sticker to tell for sure. Nice frame and birdcage, no signs of rust. Newer bc/cc paint and Al Knoch leather interior. Has side pipes and repo bolt-ons. Looks, runs and drives very nice. Asking price $45K. Reasonable offers considered. Located in Birmingham, Al.

205 744-2025 Home
205 533-2033 Cell

For more photos, go to:
http://photobucket.com/albums/v209/6...67%20Corvette/

Kensmith

Very nice car. Too bad you are so far away as I really like it. Do align the l-rear bumper though. Great car..............

62fuelie

I've had that car for 10 years or so and never noticed. I'll take a look at the bumper tomorrow.

Snohomish Vette

Nice car. Actually the car looks like it is higher on the right side (or lower on the left). Otherwise bumper looks ok. Maybe it is just the driveway that makes it look that way. It should sell quick. Bill.

62fuelie

It's a combintion of the driveway and the left rear tire was low on air pressure.

savewave

I saw the car on display at the Birmingham International Auto Show earlier this year. It's a beaut!

Kensmith

Take out a tape measure and do a quick check on the distance from the tail light to the top of the bumper on both sides. The left side appears to be a bit down. Should be a simple alignment. It will photo better also. Yes, I am a stickler for perfection and you have such a nice car it should look it's best.

62fuelie

Sold

Kensmith

Figures, nice cars go fast.

62fuelie

So much for all the nitpickers.

Jeff Garner

That was fast. Congratulations.

Seems that bumper must not have been too much out of line.

62fuelie

Had it been a musem piece instead of a driver, the price would have been $25K higher.

65convt

SEEVT65

If PRO TEAM had it, it would have been $25K higher! The best deals/cars are right here on the Forum. I have seen it time after time. Enuf' said.

jntdysf

Maybe even higher if they transplanted a BB into it.

Kensmith

You try and help a guy sell his car and someone has to make a negative comment. SORRY

Can't help myself, I build hotrods and notice stuff.

62fuelie

The bumper did need a tad of adjustment, it just wasn't an issue in the big picture.