Looking for a powerglide tail housing
#1
Team Owner
Thread Starter
Member Since: May 2005
Location: Madison - just west of Huntsville AL
Posts: 31,361
Received 1,283 Likes
on
732 Posts
Looking for a powerglide tail housing
I'm looking for a Corvette tail housing for a cast iron powerglide for a 56 I recently bought. The tail housing will have the shifter mounting flanges. Original or repo is fine (assuming a repo exists). Any and all leads appreciated.
#2
Advanced
Member Since: Dec 2005
Location: St. Charles Illinois
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
powerglide tail shaft
emccomas,
I do not have a tail housing but I do have a rear trans mounting bracket. (the horseshoe).
as for the tail housing. Do not know of any repos. but I have heard that they can weld on the three bosses. just need a good welder.
If you have a need for the bracket $50. plus $6.(for ups)= total $56.
email me at race2fast@aol.com
Good Luck,
Jim
I do not have a tail housing but I do have a rear trans mounting bracket. (the horseshoe).
as for the tail housing. Do not know of any repos. but I have heard that they can weld on the three bosses. just need a good welder.
If you have a need for the bracket $50. plus $6.(for ups)= total $56.
email me at race2fast@aol.com
Good Luck,
Jim