leslehman

I have a nice set of hooker stainless headers for my '60 with a 327. I removed the stock ones, and am getting ready to install the headers, but it appears I may have to remove the engine to do so. Is there a way to wiggle them in, do I have to remove eveyrthing around it or do I need to remove engine to install?

jforb

Headers are usually installed from below. Are you trying to install them from above?

Vette5311

Beware. There are people selling headers that are listed to fit C1 but are really for C2 and aren’t exactly the same. Check them out closely.

Pop Chevy

Get it up in the air and come in from below.

62vetteuk

you might not have to remove the engine completely. just lift it a little to allow some more room

John S 1961

This is the way.