Dual Quads Kick Down
#1
Le Mans Master
Thread Starter
Dual Quads Kick Down
Does anyone know the length of the kick down rod for a 60 dual quad with an automatic?
I have been unable to find one so I'm going to fabricate it. It looks like it is 3 5/8" shorter than the one for a single 4bbl but not positive.
Where can I find the instructions as to how to properly adjust it once I have it installed?
Thanks as always
Capt Van
I have been unable to find one so I'm going to fabricate it. It looks like it is 3 5/8" shorter than the one for a single 4bbl but not positive.
Where can I find the instructions as to how to properly adjust it once I have it installed?
Thanks as always
Capt Van
#2
Team Owner
Member Since: Oct 2000
Location: Washington Michigan
Posts: 38,899
Received 1,856 Likes
on
1,099 Posts
The cast iron Powerglide kickdown linkage adjustment procedure is shown on page 7-4 in your ST-12 manual; it's also in the Powerglide section in your Assembly Manual.
#3
Le Mans Master
Thread Starter
No one has a 2x4 with powerglide?
Just need the measurement from the carb to the bracket on trans.
Pleeeeeeeeease
Just need the measurement from the carb to the bracket on trans.
Pleeeeeeeeease