You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join Corvetteforum.com today!
Are your plans to make it back original, or a driver which is not 100% pure but fun to drive? (NOT implying a 100% original is not fun to drive also). There is no right or wrong, it's whichever way you feel like doing it. Either way there are guys here who have done the same, so don't be afraid to ask questions when you hit a snag!
Wow, that's going to be one expensive restoration! There's hardly anything original that's salvageable on the whole car. Too bad the trunk irons are missing as well....:...$$$
If your plan is to end up with a mostly original car, this is probably not the right candidate. Being a transitional year, '58 parts can be quirky, just to figure out what the correct part is. Expensive too (trunk irons for example).
But if your end goal is a "budget driver", then that may be realistic.
Anyway, I sure admire your courage!
BTW: what the heck happened to that deck panel? Never seen one so distorted.
Are your plans to make it back original, or a driver which is not 100% pure but fun to drive? :
Same question I had, you can get a lot more car for a lot less money for a driver, particularly with a 58. Restoration $$$ can go through the roof the closer you get to "original". Good luck with whatever path you take.
The OP has stated doing a total resto so it may work out better to restore this one than to pay for a much more expensive one and totally restore that, could be a case of 'what you lose on the swings you gain on the roundabouts'.
Nut and bolt restorations aren't cheap regardless.
Last edited by StephenSLR; 01-18-2012 at 12:27 AM.