SOLD : 1967 L79 Coupe
#1
Instructor
Thread Starter
SOLD : 1967 L79 Coupe
Moving to a smaller home next month and I need to sell a couple of Corvettes. I have a Marina Blue/Bright Blue vinyl '67 coupe. The car is very original with the exception of a single repaint sometime in the 1980's. The paint has some bubbles and cracks and is driver quality. Chrome and stainless are in very good condition. Birdcage is in good shape as is the frame (it was undercoated at some point in time). 327/350 hp (L79) with an M-21 4 spd. and a posi 3.70 rear end. Power brakes and manual steering with transistor ignition (very rare on a small block). Factory appearing side exhaust was added at some point by a prior owner. In the past couple of years I have restored the seat frames and had Corvette America replace the foam and seat covers. I replaced the fuel tank, had the original fuel sending unit restored and replaced the rear wiring harness. I have recently replaced the head liner and the door panels and interior are in very good condition. The clock and radio do not work and need to be restored.
The engine, transmission and rear end are numbers matching, however the carb is a service replacement from the early 70's. All glass is original with the exception of the windshield. I have a new brake booster and master cylinder that have yet to be installed with all correct stampings/markings.
I was planning to install a stroker motor and decided to start disassembly last year. Engine is still in the car but the radiator, exhaust manifolds, side pipes, carb, etc. have been removed. The car ran fine prior to disassembly. I have all parts, fasteners are bagged and labeled, etc. It has Vintage Air but I did remove all under hood components, all interior parts are still installed. The build sheet was not present when I removed the fuel tank, however, I do have the protect o plate. I would prefer to sell as is. ****SOLD****
The engine, transmission and rear end are numbers matching, however the carb is a service replacement from the early 70's. All glass is original with the exception of the windshield. I have a new brake booster and master cylinder that have yet to be installed with all correct stampings/markings.
I was planning to install a stroker motor and decided to start disassembly last year. Engine is still in the car but the radiator, exhaust manifolds, side pipes, carb, etc. have been removed. The car ran fine prior to disassembly. I have all parts, fasteners are bagged and labeled, etc. It has Vintage Air but I did remove all under hood components, all interior parts are still installed. The build sheet was not present when I removed the fuel tank, however, I do have the protect o plate. I would prefer to sell as is. ****SOLD****
Last edited by 67 L79; 05-01-2020 at 11:10 AM. Reason: Car sold.
#4
Melting Slicks
Where is the car located?
The following users liked this post:
Jeff Garner (05-01-2020)