Hardbar interior panel cutting template
04-17-2014, 03:44 PM
#1
Hardbar interior panel cutting template
Does anyone have Hardbar interior panel cutting template for C6?
I got hardbar harness bar, but don't have cutting template.
I tried to contact Hardbar, using the number provided on their website, but I keep getting "message box is full" voice message.
(I was originally trying to purchase pre-cut panel from them. Their website didn't accept payment and kept going back to previous page, so I called but no luck there either.)
Anyway,,, if anyone has template for cutting hole or knows where I can get those template, that would be really appreciated.
Thank you.
(posting same thread in C6 general section)
I got hardbar harness bar, but don't have cutting template.
I tried to contact Hardbar, using the number provided on their website, but I keep getting "message box is full" voice message.
(I was originally trying to purchase pre-cut panel from them. Their website didn't accept payment and kept going back to previous page, so I called but no luck there either.)
Anyway,,, if anyone has template for cutting hole or knows where I can get those template, that would be really appreciated.
Thank you.
(posting same thread in C6 general section)
04-17-2014, 06:23 PM
#2
Tech Contributor
Member Since: Oct 1999
Location: Charlotte, NC (formerly Endicott, NY)
Posts: 40,078
Received 8,918 Likes
on
5,327 Posts
Does anyone have Hardbar interior panel cutting template for C6?
I got hardbar harness bar, but don't have cutting template.
I tried to contact Hardbar, using the number provided on their website, but I keep getting "message box is full" voice message.
(I was originally trying to purchase pre-cut panel from them. Their website didn't accept payment and kept going back to previous page, so I called but no luck there either.)
Anyway,,, if anyone has template for cutting hole or knows where I can get those template, that would be really appreciated.
Thank you.
(posting same thread in C6 general section)
I got hardbar harness bar, but don't have cutting template.
I tried to contact Hardbar, using the number provided on their website, but I keep getting "message box is full" voice message.
(I was originally trying to purchase pre-cut panel from them. Their website didn't accept payment and kept going back to previous page, so I called but no luck there either.)
Anyway,,, if anyone has template for cutting hole or knows where I can get those template, that would be really appreciated.
Thank you.
(posting same thread in C6 general section)
Bill
04-18-2014, 10:05 AM
#4
