DNX8120 Wiring Question

slplank · 03-20-2010, 06:06 PM

I have a lot of wires up front as I have aftermarket speakers, sub, 2 amps, BU camera, iPod controls, NAV and Sat antennas etc. Although there is a lot of room around the area I'm thinking of thinning out some of the Kenwood wiring I'm not using. Is there any issue with me cutting off the Video 1, Video 2, Video Out leads on the Kenwood video harness? The only wire in that harness I need is the camera input wire. I realize if I ever want to sell or use elsewhere someone may need a new harness but I don't see that in the future and maybe I'll pick up a replacement harness to have just in case.
thanks

pentavolvo · 03-20-2010, 06:07 PM

maybe just pop the pins and pull em out of the connector vs cutting

slplank · 03-20-2010, 06:15 PM

Quote:

Originally Posted by pentavolvo

maybe just pop the pins and pull em out of the connector vs cutting

Surprisingly that is a very small connector so not sure I can pop the pins but a good idea and I'll give it a try first.

slplank · 03-20-2010, 06:38 PM

Quote:

Originally Posted by pentavolvo

maybe just pop the pins and pull em out of the connector vs cutting

Once again you are the Master! Pins are popped and connectors are out.