Cup Holder Install?
#1
Instructor
Thread Starter
Cup Holder Install?
Hi all, just received my new single cup holder from CorvetteMods today,
and was surprised to find no directions, fasteners, tape etc. to mount
the holder. From pics I've seen I know it looks clean/almost factory when
it's in the car. My vette is stored and covered so I can't just check it out
right now,(plus it's only -5*) Just curious how it attaches, hoping I'm not
missing anything in the box. Won't get the car out til April.
Thanks for any help.
Dan 91 Convertible
and was surprised to find no directions, fasteners, tape etc. to mount
the holder. From pics I've seen I know it looks clean/almost factory when
it's in the car. My vette is stored and covered so I can't just check it out
right now,(plus it's only -5*) Just curious how it attaches, hoping I'm not
missing anything in the box. Won't get the car out til April.
Thanks for any help.
Dan 91 Convertible
#2
Safety Car
If it's the one that goes on passenger side, it just slides under the lip of the console and rests on the floor, position it back towards seat as far as you can it won't go anywhere.
#5
Drifting
#8
Instructor
Thread Starter
#9
Instructor
The following users liked this post:
jseremba (11-06-2020)
#11
Le Mans Master
That is why I used the double cup holder I bought as a template and made my own from sheet Al covered with felt. Then I pop riveted two folding, collapsible cup holders to it so my wife would have more leg room when we were not using them. Covered the edges with aftermarket car door edge trim. Sold my purchased cup holder on eBay.
#12
Instructor
#14
Team Owner
Member Since: May 2000
Location: Plantation Florida USAF(Retired) 1966-1990
Posts: 47,847
Received 4,499 Likes
on
3,586 Posts
U.S. Air Force
St. Jude Donor '05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16-'17-'18-'19-'20-'21-'22-'23-'24
NCM Sinkhole Donor
#15
Melting Slicks
That is why I used the double cup holder I bought as a template and made my own from sheet Al covered with felt. Then I pop riveted two folding, collapsible cup holders to it so my wife would have more leg room when we were not using them. Covered the edges with aftermarket car door edge trim. Sold my purchased cup holder on eBay.
#16
Stellabarbara
Got one from Ecklers... It was easy to install. However, it does not fit snug up against the carpet???? I had to take double sided 3M tape to get it to lay a little flatter. However, it still sticks out at the bottom. Two sided tape does not work. Other than that, it looks really good and works very well with my Speedway coffee cup.
#17
Safety Car
Cup holders
Both the single and double slip under the lip. My 86 had a single in it when I got it, but needed two. Once slips out and the other slips in, easy to do.