R&L's C6

I don't know if this has been talked about yet, but I wonder if the C7 will suffer the same fate at the dealers as the C6....cracked rockers. Does anyone know if jacking pucks will be needed on the C7?

sam90lx

They are already lifted, have'nt you seen the fender gap?

gthal

Way to go with a meaningful and completely untroll like response

talon90

Hey Randy,

They will lift similar to the C6/Z06 and yes, if not done properly will suffer the same fate as the C6.

-CM-

Do you think the jacking pucks I currently have on my C6 will work with the C7?

talon90

What type of jacking pucks do you currently have?

R&L's C6

Thanks, Paul

So it's just a matter of time before we get the first "dealer cracked my rockers" thread in the C7 section...

-CM-

These from Southern Car Parts.

talon90

Those should work just fine.

Zymurgy

Paul, will the Elite Engineering pucks work on the C7?

mpuzach

You can't use pucks that say "C5" on them on a C7 even if they do fit!

DREAMERAK

This is true...

AmmoVet

Those are BMW pucks, I picked up mine from a BMW Parts Counter and have had them permenantly installed since 2006. total cost was around $30 if I remember correctly.

Zymurgy

The ones that I have actually have "C6" on them, so they'll only be one generation off.

SCM_Crash

I would imagine the C7 will be harder to lift from the back. On the C5s I put a piece of wood across the cradle beams in the back and lift from the wood. But I suspect that the C7 is going to be completely different back there.

I'm just glad I won't be doing any work on it for a few years.