[Z06] Installed Katech Carbon Fiber Valve Cover and Coil Relocate
#1
Melting Slicks
Thread Starter
Member Since: May 2007
Location: Peoria Arizona
Posts: 2,652
Likes: 0
Received 0 Likes
on
0 Posts
St. Jude Donor '11
Installed Katech Carbon Fiber Valve Cover and Coil Relocate
Turned out better than i could expect.
Last edited by azZ06Mike; 03-29-2013 at 10:59 PM.
#3
Le Mans Master
Looks awesome!
Did you install it yourself? If not how much did the install cost if you don't mind sharing
Did you install it yourself? If not how much did the install cost if you don't mind sharing
#6
Melting Slicks
#10
Melting Slicks
Thread Starter
Member Since: May 2007
Location: Peoria Arizona
Posts: 2,652
Likes: 0
Received 0 Likes
on
0 Posts
St. Jude Donor '11
bumping between 11.5 to 12.1.
Car is
livernois stage 2 cam
wcch stage 2 heads
ported ls7 intake
kooks headers
corsa cat back
mcleod rxt twin disk
haltech cold air intake
katech valve covers
coil relocate
msd wires
ngk tr6 plugs
dyno tune with hptuners
Car is
livernois stage 2 cam
wcch stage 2 heads
ported ls7 intake
kooks headers
corsa cat back
mcleod rxt twin disk
haltech cold air intake
katech valve covers
coil relocate
msd wires
ngk tr6 plugs
dyno tune with hptuners
#12
Melting Slicks
Member Since: Nov 2002
Location: North shore,Ma./Naples Florida
Posts: 3,059
Received 272 Likes
on
144 Posts
Looks awesome. Anyone on here that defends the oem plastic covers really need to look at some of these conversions to get the point of how these engines should really look.
#13
Race Director
Very good looking. What plug wires did you use, Mike?
#19
Drifting
I just did the same Katech install and love them. The only option I found was for the red MSD wires. I noticed yours are black. I found the MSD wires to be about 1/2 inch shorter than I liked. They were under a little tension and dead straight.
Gary
Gary
Last edited by 40YRW8; 04-01-2013 at 04:39 PM.