[Z06] My PRC 265s just showed up
#4
Le Mans Master
looking good.......any details ? for example.......milled? yes/no, if not what c/r will you get and if so, how much to achieve how much c/r ?
thanks
thanks
#5
Melting Slicks
Thread Starter
#7
Drifting
Member Since: Feb 2006
Location: Cocoa Florida
Posts: 1,890
Likes: 0
Received 0 Likes
on
0 Posts
Would it be too much to ask if you could possibly get john's tool to measure some parts on the head so we know how an aftermarket cast measures up to the stock we are measuring?
also, going to go with stock rockers or rollers?
also, going to go with stock rockers or rollers?
#8
Melting Slicks
Thread Starter
I am going to bolt on the stock rockers and see what the geometry looks like and go from there.
#9
Team Owner
#10
Drifting
Member Since: Feb 2006
Location: Cocoa Florida
Posts: 1,890
Likes: 0
Received 0 Likes
on
0 Posts
excellent! i dont know where his tool is though, can you pop him a PM and see if it would fit your time constraints?
mainly i want to see where your valve lines up and rocker pedestal heights compared to the stock 'bad' heads.
mainly i want to see where your valve lines up and rocker pedestal heights compared to the stock 'bad' heads.
#11
Burning Brakes
Hopefully the tool will be here in Hawaii tomorrow. My spark plugs are out, coil packs off, all tools at the ready, a Vacation day taken and fingers crossed.
#14
Safety Car
Member Since: Dec 1999
Location: Virginia Beach, VA & Port Charlotte, FL (snowbird)
Posts: 4,407
Received 1,095 Likes
on
578 Posts
You'll love the results!!
One of the best things I did for my Z was installing the PRC265s. My geometry was textbook and they flow like gang busters!
Go with the NW throttle body and the FAST 102 then you too will become a torque addict.
Peace of mind alone is worth the price...
One of the best things I did for my Z was installing the PRC265s. My geometry was textbook and they flow like gang busters!
Go with the NW throttle body and the FAST 102 then you too will become a torque addict.
Peace of mind alone is worth the price...
#18
Melting Slicks
Thread Starter
Ti intake , SS exhaust
I can always do it later. Just need to pop a valve cover and a rocker.
Ya I'd like to do the FAST and NW TB but I'm going to wait a little bit till I do that
You'll love the results!!
One of the best things I did for my Z was installing the PRC265s. My geometry was textbook and they flow like gang busters!
Go with the NW throttle body and the FAST 102 then you too will become a torque addict.
Peace of mind alone is worth the price...
One of the best things I did for my Z was installing the PRC265s. My geometry was textbook and they flow like gang busters!
Go with the NW throttle body and the FAST 102 then you too will become a torque addict.
Peace of mind alone is worth the price...
Ya I'd like to do the FAST and NW TB but I'm going to wait a little bit till I do that
Last edited by 69dodgecharger; 12-20-2012 at 11:33 AM.