mike88amped

Ok I have seen tons of post on this subject and I have spent alot of time checking places....I need a power steering pulley for a 1996 lt1 Corvette . I have tried several places listed in the post,but everyone says they are no longer available,spent a half hour on phone with speed inc.today and they could not find one either.any help would be great thanks

mike88amped

Anybody out there help!!!!!!!!!!!!

Jonnymac

found mine on ebay. good luck

bjm206

The link below allows you to search across multiple salvage yards for parts by distance from your location.

http://www.mypartshop.com/

I saw a few hits on pumps from your model year. Give one of them a call and see if they will just sell you the pulley or if not sell you a pump with the pulley.

mike88amped

thanks for the info i will check it out...

93Rubie

That would be smooth sided steel pulley, yeah, good luck. No one makes them anymore. All that is available is Ebay, swap meets, salvage yards. I got one last year from a Corvette Salvage yard.

Ironically, they make the 92-E93 plastic ones. $400 a pop.

Why do you need one?

mike88amped

Mine has a really bad wobble in it and I have been through 2 altenators ...had it checked by GM dealer and they say the wobble is causing problem with alternator bearings

Muffin

No question about needing a straight pulley but I wonder about causing alternator bearings to fail. Idle thought: can a pulley be straightened?

93Rubie

In theory, it could make the tension from the belt misaligned and the load the bearings in a way they where not designed to be loaded.

I would check your idlers and tensioner as well for good bearings/no play,etc...Check pulley alignment with a straight edge, specs. are in FSM.

What I want to know is how does a steel pulley get bent?

derekguzz

Well mines bent as well and looking for a replacement

gerardvg

Remember do not try to fit a new one, or remove one without the correct removal/fitting tool or you will need another.

http://www.ebay.com/itm/KASTAR-Maste...item257a47bc5c

WVZR-1

A bent pulley would indicate either an incorrect removal proceedure OR a failed attempt at an install when replaceing a pump. The only other possible explanation is that presently it's not a pulley problem but the shaft or front bearing in the pump has failed or is failing. Just sayin'

Txbobcat

I sent you a pm of a guy that parts out c4s. He will have your part

pmihaltian

I rebuilt my entire power steering system this past year and used this inexpensive pulley removal & installation kit to do the job. Worked great without error or problems. Check it out:

http://www.harborfreight.com/pulley-...set-40749.html

ScaryFast

I have a complete pump, rebuilt by turn one for sale cheap.