C6 Corvette General Discussion General C6 Corvette Discussion not covered in Tech
Sponsored by:
Sponsored by:
Old 03-05-2015, 06:14 PM
How-Tos on this Topic
Last edit by: IB Advertising
See related guides and technical advice from our community experts:

Browse all: General How-Tos
Print Wikipost

Targa top noise

Old 12-02-2009, 09:09 AM
  #1  
minor5523
Heel & Toe
Thread Starter
 
minor5523's Avatar
 
Member Since: Sep 2008
Location: Arlington TN
Posts: 19
Likes: 0
Received 0 Likes on 0 Posts

Default Targa top noise

Have anyone had targa top noise,poping.squeating, and rattling noise while driving if so what can be done about it to correct the problem.C-6 "05"coupe.

Last edited by minor5523; 12-02-2009 at 09:11 AM.
Old 12-02-2009, 09:11 AM
  #2  
mrtoner
Drifting
Support Corvetteforum!
 
mrtoner's Avatar
 
Member Since: May 2003
Location: Las Vegas Nevada
Posts: 1,328
Likes: 0
Received 3 Likes on 3 Posts

Default

Yes - check out Talon90's sticky: "C6 roof panel noise primer"

Old 12-02-2009, 09:16 AM
  #3  
not08crmanymore
Team Owner
 
not08crmanymore's Avatar
 
Member Since: Dec 2003
Location: queensbury ny
Posts: 57,309
Received 138 Likes on 119 Posts

Default

Immediately,you can put some lube/grease in the holes up front where the latches go.Right down in there where the shiny part is up front. Then,look in to new latches from the dealer that gm issued a while back.
Old 12-02-2009, 09:21 AM
  #4  
RadarP3C
Race Director

 
RadarP3C's Avatar
 
Member Since: Mar 2007
Location: Murfreesboro TN
Posts: 10,151
Received 28 Likes on 19 Posts

Default

Had the new latches installed yesterday.

One day of quiet (no roof popping) so far....
Old 12-03-2009, 08:35 PM
  #5  
minor5523
Heel & Toe
Thread Starter
 
minor5523's Avatar
 
Member Since: Sep 2008
Location: Arlington TN
Posts: 19
Likes: 0
Received 0 Likes on 0 Posts

Default

Thanks to all who replied to my thread I think the info will be very helpful.
Old 12-03-2009, 09:44 PM
  #6  
ohmy
Melting Slicks
 
ohmy's Avatar
 
Member Since: Mar 2007
Location: Central NJ
Posts: 2,485
Likes: 0
Received 3 Likes on 2 Posts
Default

there is no permanent fix, the popping and squeeking will come back, there is no fix, just a temporary band-aid - grease, reposition, e-clips, felt, take your pick, all temporary...
Old 12-03-2009, 09:46 PM
  #7  
nmerhaut
Melting Slicks
 
nmerhaut's Avatar
 
Member Since: Nov 2007
Location: Cleveland, OH
Posts: 2,470
Received 75 Likes on 62 Posts

Default

Did the e clips over a year ago and no more snap, crackle or pop. Good luck.
Old 12-03-2009, 09:51 PM
  #8  
bob guzzy
Safety Car
 
bob guzzy's Avatar
 
Member Since: Jan 2006
Location: shavertown Pa.
Posts: 3,940
Received 41 Likes on 37 Posts

Default

Mine started making noise out of a clear blue, I just took the top off and put it back and it was gone and still is.
Old 02-08-2010, 12:25 PM
  #9  
aloandnina
Instructor
 
aloandnina's Avatar
 
Member Since: Aug 2009
Location: Killeen TX
Posts: 187
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by RadarP3C
Had the new latches installed yesterday.

One day of quiet (no roof popping) so far....
Did you have to pay for the latches or was it more like a factory recall? If you had to pay, how much was it?
Old 02-08-2010, 01:06 PM
  #10  
talon90
Team Owner
Support Corvetteforum!
 
talon90's Avatar
 
Member Since: Aug 2002
Posts: 35,617
Received 152 Likes on 72 Posts
Tech Contributor
Cruise-In 11 Veteran
NCM Ambassador
St. Jude Donor '05-'06-'07-'10

Default

Originally Posted by aloandnina
Did you have to pay for the latches or was it more like a factory recall? If you had to pay, how much was it?
If your car is under warranty they will replace the handles with the new design for free under warranty. If not, it will be out of pocket. The new design handles list for $160.00 each. Your cost will depend on where you buy them and if the dealer is willing to discount.

Part Number
Description

19206591
Handle, Roof Lift Off Panel - Left

19206592
Handle, Roof Lift Off Panel - Right

12371287 (US)

10953437 (Canada)
GM Vehicle Care Super Lube® with PTFE

Warranty Information
For vehicles repaired under warranty, use:

Labor Operation
Description
Labor Time
Old 02-08-2010, 01:37 PM
  #11  
Mike's LS3
Safety Car
 
Mike's LS3's Avatar
 
Member Since: Nov 2007
Location: Bay Area CA
Posts: 4,301
Received 730 Likes on 472 Posts

Default

Originally Posted by ohmy
there is no permanent fix, the popping and squeeking will come back, there is no fix, just a temporary band-aid - grease, reposition, e-clips, felt, take your pick, all temporary...

I must be lucky, two years and no more popping. I did the following:

1. Make sure the pins on the targa top are tight.
2. Make sure the roller retainers (the metal retainer the roller sits in when secured) do not have play in them. Bend the metal tabs to remove any play. One of my retainers were lose and made noise.
2. Install the e-clips on the rollers.
3. Lube the rollers, retainers and pins with Dielectric grease.
4. Apply silicone spray on the top weatherstripping.

Every six months I will lube all the above areas and (knock on wood) no more popping or clicking.

OR GET THE NEW HANDLES, BUT SOME HAVE REPORTED THE NOISE RETURNED!

Last edited by Mike's LS3; 02-08-2010 at 01:41 PM.
Old 02-08-2010, 06:16 PM
  #12  
LS WON
Team Owner
 
LS WON's Avatar
 
Member Since: Dec 2002
Location: San Francisco CA
Posts: 31,954
Received 271 Likes on 233 Posts

Default

or buy a hardtop = Z-06
Old 02-08-2010, 06:33 PM
  #13  
aloandnina
Instructor
 
aloandnina's Avatar
 
Member Since: Aug 2009
Location: Killeen TX
Posts: 187
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by Mike's LS3
I must be lucky, two years and no more popping. I did the following:

1. Make sure the pins on the targa top are tight.
2. Make sure the roller retainers (the metal retainer the roller sits in when secured) do not have play in them. Bend the metal tabs to remove any play. One of my retainers were lose and made noise.
2. Install the e-clips on the rollers.
3. Lube the rollers, retainers and pins with Dielectric grease.
4. Apply silicone spray on the top weatherstripping.

Every six months I will lube all the above areas and (knock on wood) no more popping or clicking.

OR GET THE NEW HANDLES, BUT SOME HAVE REPORTED THE NOISE RETURNED!
Can you show me a pic of the e clips?
Old 02-08-2010, 07:55 PM
  #14  
PARANORMAL
SUPPORT AUTISM
Support Corvetteforum!
 
PARANORMAL's Avatar
 
Member Since: Sep 2009
Location: Suffolk County New York
Posts: 1,939
Received 40 Likes on 19 Posts
St. Jude Donor '10, '14

Default

You may want to check out this other thread, I had the same problem and I went to Sears and bought the clips and a little grease and its all gone. It's amazing, if your out of warranty is $160.00, go to Sears and spend $1.00 and you get the same result.
http://forums.corvetteforum.com/c6-c...ing-noise.html
Old 02-08-2010, 07:58 PM
  #15  
beaversstonehaven
Melting Slicks
 
beaversstonehaven's Avatar
 
Member Since: Feb 2005
Location: San Marcos, Texas
Posts: 2,633
Received 129 Likes on 100 Posts

Default

Originally Posted by nmerhaut
Did the e clips over a year ago and no more snap, crackle or pop. Good luck.
Same here. Thanks Mrtoner! I never thought that fix would work but in my case it did the trick.
Old 02-08-2010, 08:11 PM
  #16  
Dif
Safety Car
Support Corvetteforum!
 
Dif's Avatar
 
Member Since: Mar 2009
Location: Northeast MA & Mad Beach FL
Posts: 4,101
Received 716 Likes on 436 Posts

Default

I usually treated the weather stripping on my 09 about once a month since new.
It took about 7 months before I started getting the popping sound.

Treated the weather stripping and put a little white grease on the pins and rollers.
Stopped the noise right away
Old 02-09-2010, 01:17 AM
  #17  
Mike's LS3
Safety Car
 
Mike's LS3's Avatar
 
Member Since: Nov 2007
Location: Bay Area CA
Posts: 4,301
Received 730 Likes on 472 Posts

Default

Originally Posted by aloandnina
Can you show me a pic of the e clips?
Do a search: "5/32 e-clip top repair" Go to post #23 for a picture of the e-clip and where to install it.
Old 07-19-2011, 12:37 PM
  #18  
robforster
Advanced
 
robforster's Avatar
 
Member Since: Oct 2004
Location: Lincoln California
Posts: 82
Likes: 0
Received 0 Likes on 0 Posts

Default

My GS coupe without rollers in the handles pops like popcorn with any tweak of the body or pothole (California). Lubed many times. Dealer lost. There used to be a link for those without rollers and the fix including gromets on the posts, gluing the plastic to the windshield, etc. Anyone have it? About 20 pages long

2010 GS Coupe

Get notified of new replies

To Targa top noise



Thread Tools
Search this Thread
Quick Reply: Targa top noise



All times are GMT -4. The time now is 03:28 PM.