WTB - L98 aluminum heads #10088113
#2
Burning Brakes
Member Since: Apr 2004
Location: Stanfield NC
Posts: 792
Likes: 0
Received 0 Likes
on
0 Posts
i have a set complete with valves, springs, rockers, guide plates etc. for $500.00 + shipping. I ONLY do USPMO, so tha tmey be a problem for you. PM me if you are interested.
#4
#8
Race Director
slickfx3 has an '89 (look at his profile) So his perspective sale would be the same head.
Vader's website has more info on the L98 heads... http://temp.corvetteforum.net/c4/vader86/
#9
new here looking for spring pads 10088113
hi i am looking for a set of spring pads for my aluminum vett heads casting # 10088113
the valve springs sit on top of these pads..
i can't find them any where???? ..
does any one have a used set they would sell??
let me know if you have any of them i have a few of them, my old machine shop lost a bunch of them on me..
the valve springs sit on top of these pads..
i can't find them any where???? ..
does any one have a used set they would sell??
let me know if you have any of them i have a few of them, my old machine shop lost a bunch of them on me..
Last edited by will1972rupp; 08-21-2010 at 12:49 PM. Reason: wanted spring pads for 10088113 vett aluminum heads
#11
Racer
hi i am looking for a set of spring pads for my aluminum vett heads casting # 10088113
the valve springs sit on top of these pads..
i can't find them any where???? ..
does any one have a used set they would sell??
let me know if you have any of them i have a few of them, my old machine shop lost a bunch of them on me..
the valve springs sit on top of these pads..
i can't find them any where???? ..
does any one have a used set they would sell??
let me know if you have any of them i have a few of them, my old machine shop lost a bunch of them on me..
You'll need to know the ID and the OD of the seat plus the thickness is helpful if you're trying to match the stock ones - if not just replace the set of 16 and check/set the valve spring installed height.
#13
block head combo
hello all I am new here and picked up this project. the block is a 1980 5.7 carb motor casting number 14010207 and I have what I believe are L98 ZZ3 heads casting number 10088113. can any one tell me if these are compatable for use. I have heard yes and no on this.
#14
Racer
They'll physically bolt on the block and as they were the stock casting in the late 80's they should bolt up to your TPI intake if you're running it. These heads were good "back in the day" but they have been overshadowed by the many advancements in head design so if you have to spend much on them to freshen them up I'd tell you to really think about it. If they're ready to go then just run them BUT make sure the valve spring setup can handle the cam lift you're going to put with it as the stock springs were really light/weak and didn't support higher lifts on a modern designed roller cam.