How much slack in inner diff axles?
#1
Drifting
Thread Starter
How much slack in inner diff axles?
Hello!
How much slack/end play is acceptable in read end inner axles? Is there any factory tolerance?
btw do they have any role working as an control arm ? I meand do they have to hold half shaft inboard ??
How much slack/end play is acceptable in read end inner axles? Is there any factory tolerance?
btw do they have any role working as an control arm ? I meand do they have to hold half shaft inboard ??
#3
Race Director
When new or after a rebuild you should see no more than 0.010" to 0.015" play. I would start thinking of a rebuild if I saw more than 0.050" play as the hardened part at the end of the yoke is not very thick. After it goes through the hardened part play increases rapidly and if the end mushrooms it will be difficult to remove.
#4
Drifting
Thread Starter
Thank you !!
One more; is the excessive end play cured just replacing new axles and clip? That will do it ? I will open it soon .I try to post a picture of the shafts ring lands.
One more; is the excessive end play cured just replacing new axles and clip? That will do it ? I will open it soon .I try to post a picture of the shafts ring lands.