Edelbrock Performer RPM heads
02-15-2005, 08:43 PM
Racer
Thread Starter
Member Since: Jul 2001
Location: Winston-Salem NC
Posts: 363
Likes: 0
Received 0 Likes
on
0 Posts
Edelbrock Performer RPM heads
These heads were on my 350 motor when I bought the car. According to the Jeg's catalog, they come in 64cc and 70cc versions. Is there any way to tell which I have?
Thanks!
Jeff
02-15-2005, 08:53 PM
The ORIGINAL and bestest
Member Since: Oct 2000
Location: Toronto Ontario
Posts: 10,009
Toronto Events Coordinator
You can tell by the part number, which I believe is stamped in the top of the head. Pull the vavle cover to find it.
02-15-2005, 09:09 PM
Racer
Thread Starter
Member Since: Jul 2001
Location: Winston-Salem NC
Posts: 363
Likes: 0
Received 0 Likes
on
0 Posts
OK, there's a raised 6061 cast into the head. A couple of cylinders down, there's a small 8020 stamped into it. Does that help?
02-15-2005, 09:13 PM
Melting Slicks
Member Since: Dec 2000
Location: Wichita, KS
Posts: 2,041
Likes: 0
Received 0 Likes
on
0 Posts
6061 would indicate a set of 70c.c. Edelbrock Performer RPM angle plug heads heads.
02-15-2005, 09:14 PM
The ORIGINAL and bestest
Member Since: Oct 2000
Location: Toronto Ontario
Posts: 10,009
Toronto Events Coordinator
Dug out my old Edelbrock catalog and......6061 is a Performer RPM angled plug 70cc bare head. Hope this helps
02-15-2005, 09:31 PM
Racer
Thread Starter
Member Since: Jul 2001
Location: Winston-Salem NC
Posts: 363
Likes: 0
Received 0 Likes
on
0 Posts
All right, thanks guys. I knew this was the right place to ask!!!!
350 ,
6061 ,
edelbrock ,
edlebrock ,
forum ,
heads ,
intake ,
lifter ,
performer ,
permormer ,
preformer ,
removing ,
review ,
rpm ,
without